Send to a Friend!

Angle connector orientation

If you order right angle connectors installed on dual cables, or short single cables (less than 10 feet), we will need to know how you want the angle configured on each end of each cable, as these do not swivel or turn on the cable. There will be a place to put a note on the shopping cart page to specify the installation.
Here are some sample diagrams to help simplify ordering.

The picture diagrams below show how we number different configurations of the right angle connector installation on dual cables.
The degree numbers are referenced to the cable as if you were looking straight into the end of the bare cables. Up is 0 degrees, right is 90, down is 180, and left is 270. If you are looking at end A, coax 1 is on your left, coax 2 is on your right. If you look in to cable end B, it is the opposite, with coax 2 on the left, and coax 1 on the right. The connectors are numbered 1a, 2a, 1b, & 2b. The configuration number is the 4 connector numbers, each one followed by the rotational degree of installation.
Single cable configurations can be specified by just using 1a and 1b degree numbers.

The first picture below shows the default selection. This is how we will install your connectors if you don't specify differently. The connectors are installed all pointing the same way, 0 degrees. The other pictures show some other examples with configuration numbers.